Videos and Tutorials

Configuring Konect to Collect Data

April 26, 2017 (3:35)

Follow along to get Konect set up to collect data from a data logger with a fixed IP address. This could be a CR1000 with an NL116, a CR6, a CR 310, or another PakBus™ data logger that is accessible via an IP address. Before you get going,

PVS5120-Series Samplers | CR1000 Connection (Part 3)

February 13, 2015 (3:33)

Part 3 of a three-part series demonstrating how to set up a CR1000 datalogger to communicate with and control a PVS5120C or PVS5120D vacuum pump water sampler using the SDI-12 mode.

Wireless Sensor Networks | Setup (Part 2)

February 1, 2013 (14:03)

Part 2 of a two-part series demonstrating how to set up a wireless sensor network using a CWS900 wireless sensor interface, a tipping bucket rain gage, a CWB100 wireless-sensor base, a CR1000 datalogger, the Device Configuration Utility, an

LoggerLink Software | An Introduction

January 29, 2013 (12:11)

An introduction to the features of the LoggerLink Mobile App, which allows a mobile device to communicate with IP-enabled dataloggers (CR200X, CR800, CR850, CR1000, CR3000, CR6). Field maintenance tasks such as viewing and collecting data,

CR1000 Datalogger | Wiring Panel

October 18, 2010 (7:18)

A description of the main channel types available on the CR1000, CR800, CR850, CR3000, and CR5000 dataloggers: analog input, analog output, pulse counters, and digital I/O. Includes a discussion of the types of sensors that can be connected

Wiring a Datalogger to a Multiplexer

October 14, 2010 (7:18)

A demonstration of how to expand the number of analog input channels on a CR1000 datalogger by wiring it to an AM16/32 multiplexer.

Multiplexer Programming with a CR1000 Datalogger

October 13, 2010 (6:09)

A tutorial demonstrating how to create a program that uses an AM16/32 multiplexer to measure up to 32 analog sensors on a CR1000 datalogger. The sensors used in this example are Type T thermocouple temperature sensors, but any analog (volta