AL200X

Added additional SDI-12 debugging and require temporarily disabling scheduled communication with peripherals when sending commands to SDI-12 sensors to prevent bus contention from long replies. Replies longer than the AL200X’s buffer will be truncated, since that info is normally available in the sensor’s manual (e.g. a very long response to aXHELP!).

Added P1 Accumulator report format as 1 to 4-byte TBRG or GSR (with settable roll-over value). Default is 2-byte TBRG.

Improved test button behavior in both ALERT2 and ALERT modes.

Added scheduling for ALERT transmissions to minimize transmission collisions between sites because of GPS sync’d clocks (necessary for logging). Default transmission times are based on s/n (which is also reported in DCU), with ability to override to a different transmit slot in case of collisions when deployed.

Added ALERT operating mode, and updated DCU (Device Config Utility) settings to differentiate settings for ALERT vs ALERT2. See manual for details of ALERT mode.

Clarified DCU selection of ALERT Mark and Space tones to reduce ambiguity in AL200 OS1 selections and removed deprecated pairs.

Disabled FP2 as a report format since some message parsers do not yet support it.

Filter out listing of advanced commands in terminal response to HELP. Advanced commands can be enabled for that terminal session by issuing ALLWORDS (normal behavior can be reestablished by issuing USERWORDS).

Added multiplier and offset to p1 output value.

Fixed report scheduling issues.

Require Scan and Report to be a multiple of TDMA Frame Length.